Publicité
Les langues disponibles
Les langues disponibles
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer helpline
at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
•
Main Unit
•
Handle
•
Wheel Kit
•
High Pressure Hose
•
Spray Gun
•
Adjustable Nozzle Extension
•
Oil Bottle
•
Parts Bag (which includes the following):
•
Operator's Manual
•
Safety Goggles
•
Mesh Accessory Bag
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Attach handle to main unit.
2. Install wheel kit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
All manuals and user guides at all-guides.com
ASSEMBLY
Attach Handle
1. Place handle (A) onto base (B). Make sure holes in
2. Insert carriage bolts (C) through holes from outside of
Install Wheel Kit
The wheel kit is designed to greatly improve the portability of
your pressure washer.
NOTE: Wheel kit is not intended for over-the-road use.
Install the wheel kit as follows:
1. Place the bottom of the pressure washer frame on a flat,
2. Slide a wheel (A) over the axle pin (B).
NOTE: Be sure to install wheel with raised hub inboard.
3. Slide axle pin through hole (C) in frame.
4. Retain wheel on axle pin with retaining pin (D).
5. Repeat step 2 through 4 to secure second wheel.
7
handle align with holes on base.
C
D
unit and attach a plastic knob (D) from inside of unit.
Tighten by hand.
even surface.
C
A
B
C
D
A
B
Publicité
