Publicité
Les langues disponibles
Les langues disponibles
8. Move throttle lever to "Fast" position (A), shown as a
rabbit.
A
To start the engine for the very first time:
9. Push primer bulb firmly 5 times, waiting 2 seconds
between each push.
To start engine thereafter:
9. Press primer bulb firmly 3 times, waiting 2 seconds
between each push. For a warm engine, DO NOT press
primer bulb.
IMPORTANT: Before starting the pressure washer, be sure
you are wearing adequate safety goggles.
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
10. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance. Then pull rapidly
to start engine.
All manuals and user guides at all-guides.com
• NEVER pull starter cord without first relieving spray gun
• When starting engine, pull cord slowly until resistance is felt
• After each starting attempt, where engine fails to run, always
• Firmly grasp spray gun with both hands when using high
11. Return recoil starter slowly. DO NOT let rope "snap
NOTE: Always keep the throttle lever in the "Fast" position
when operating the pressure washer.
• DO NOT allow CHILDREN to operate pressure washer.
• Keep high pressure hose connected to pump and spray gun
• NEVER aim spray gun at people, animals, or plants.
• DO NOT secure spray gun in open position.
• DO NOT leave spray gun unattended while machine is running.
• NEVER use a spray gun which does not have a trigger lock or
• Always be certain spray gun, nozzles and accessories are
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 feet (152 cm) of clearance on all sides of
• Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
11
WARNING
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
pressure.
and then pull rapidly to avoid kickback.
point spray gun in safe direction and squeeze spray gun trigger
to release high pressure. Engage spray gun trigger lock.
pressure spray to avoid injury when spray gun kicks back.
back" against starter.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
while system is pressurized.
trigger guard in place and in working order.
correctly attached.
WARNING
Contact with muffler area can result in serious
burns.
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
pressure washer including overhead.
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
Publicité
