Publicité
Les langues disponibles
Les langues disponibles
How to Stop Your Pressure Washer
1. Release spray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW position, then STOP position (A).
3. ALWAYS point spray gun in a safe direction and squeeze
spray gun trigger to release retained high water
pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
4. Engage trigger lock on spray gun when not in use.
How To Use the Adjustable Nozzle
You should now know how to START and STOP your
pressure washer. The information in this section will tell you
how to adjust the spray pattern and to apply pressure washer
specific detergents.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
All manuals and user guides at all-guides.com
1. Slide nozzle backward to achieve high pressure. Slide
A
2. Point nozzle down towards a firm surface, disengage
3. Twisting nozzle adjusts spray pattern from a fan pattern
Usage Tips
4
5
6
12
nozzle forward when you wish to adjust spray to low
pressure mode.
trigger lock, and press trigger to test pattern.
to a narrow pattern.
For most effective cleaning, keep spray nozzle from 8 to
24 inches away from cleaning surface.
If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
DO NOT get closer than 6 inches when cleaning tires.
Publicité
