Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Switching on
1.
Open the door.
2.
Load the dishes in the upper en lower basket.
3.
Add detergent and rinse agent (consult 'Dishwasher detergents' and 'Rinse aid').
Check the amount of salt in the salt reservoir (consult 'Adding Salt').
4.
Press the "on/off" button to switch on the appliance.
A cycle indicator will light up when the appliance is switched on.
5.
Select the desired cycle (see cycle selection table").
The cycle indicator corresponding to the selected cycle will light up.
6.
Close the door.
The dishwasher will automatically start running the selected cycle.
Delayed start time
•
If you want the dishwasher to switch on at a later time, you can used the delay button.
You can choose to delay the start time by 3, 6, or 9 hours. Each press of the delay button
changes the delay time.
The indicators show the delayed start time that has been selected.
Stopping or changing a wash cycle
•
Open the door.
•
Press and hold the programming button for more than 3 seconds.
You can now re-select the desired cycle (see "cycle selection table").
Close the door.
Note! A cycle that has already begun can only be changed in the start-up phase. After
this, the detergent will be sprayed all over the dishes or the machine may have already
pumped out the water. In that instance, you must refill the detergent compartment (see
section on Detergent compartment).
Following the end of the wash cycle
Once the wash cycle has completed, an audible signal will sound for eight seconds.
1.
Open the door.
2.
Switch the appliance off using the on/off button.
Wait a few minutes before unloading the dishwasher. The dishes and cutlery will still be very
hot immediately following the end of the cycle. There is a chance that dishes may break as
a result of the heat. Moreover, the dishes
dry better when allowed to stand for a few minutes.
EN 8
Publicité
