Zanussi ZDT 16011 Notice D'utilisation page 18

1)
Programme
Normal or light soil
Delicate crockery and
glassware
1) The display shows the programme duration.
The water pressure and temperature, the variations of the mains supply, the options and the quantity of dishes can change the
programme duration and the consumption values.
2) The appliance senses the degree of soil and the quantity of items in the baskets. It automatically adjusts the temperature and quantity
of the water, the energy consumption and the programme duration.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) This is the standard programme for test institutes. With this programme you have the most efficient use of water and energy
consumption for crockery and cutlery with normal soil. Refer to the supplied leaflet for test information.
Options
Multitab function
Activate this function only when you use the combi deter-
gent tablets.
This function deactivates the flow of rinse aid and salt.
The related indicators are off.
The programme duration can increase.
Activating the multitab function
Activate or deactivate the multitab function before
the start of a programme. You cannot activate or de-
activate this function while a programme operates.
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (D) and (E) at the
same time until the multitab indicator comes on.
The function stays on until you deactivate it. Press
and hold function buttons (D) and (E) at the same
time until the multitab indicator goes off.
If you stop to use the combi detergent tablets, before you
start to use separately detergent, rinse aid and dishwasher
salt, do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the rinse aid
dispenser are full.
4. Start the shortest programme with a rinsing phase,
without detergent and without dishes.
18
Degree of soil
Type of load
Wash 45 °C
Rinses
Dry
Programme phases
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the released quantity of rinse aid.
Acoustic signals
The acoustic signals operate in these conditions:
• The programme is completed.
• The level of the water softener is adjusted electronical-
ly.
• The appliance has a malfunction.
Factory setting: on. You can deactivate the acoustic
signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (B) and (C) at the
same time until the indicators of function buttons (A),
(B) and (C) flash.
4. Press function button (C),
• The indicators of function buttons (A) and (B) go
off.
• The indicator of function button (C) continues to
flash.
• The display shows the setting of the acoustic sig-
nals.
Energy Water
(kWh)
0.8 - 0.9 12 - 13
On
(l)