Publicité
Les langues disponibles
Les langues disponibles
Water Supply and Drain
Cold water connection
Connect the cold water supply hose to a
threaded 3/4(inch) connector and make
sure that it is fastened tightly in place.
If the water pipes are new or have not
been used for an extended period of time,
let the water run to make sure that the water
is clear. This precaution is needed to avoid the
risk of the water inlet to be blocked and damage
the appliance.
About the safety supply hose
The safety supply hose consists of the double walls. The system guarantees its
intervention by blocking the flow of water in case of the supply hose breaking
and when the air space between the supply hose itself and the outer corrugated
hose is full of water.
WARNING
A hose that attaches to a tap can burst if it is installed on the same water line
as the dishwasher. If your sink has one, it is recommended that the hose be
disconnected and the hole plugged.
How to connect the safety supply hose
1.Pull the safety supply hoses out from storage compartment located at rear
of dishwasher.
2.Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3.Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1.Turn off the water.
2.Unscrew the safety supply hose from the faucet.
ordinary supply hose
- 32-
safety supply hose
Publicité
