Publicité
Les langues disponibles
Les langues disponibles
Filling The Rinse Aid Reservoir
1
Remove the rinse reservoir cap by
lifting up the handle .
3
C C lose the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1.Switch on the appliance.
2.Within 60 seconds after the appliance was switched on press the program
button for more than 5 seconds, and then press the Delay button to enter the
set model, the rinse aid indication blinks as 1Hz frequency.
3.Press the Program button again to select the proper set according to your
using habits, the setting will change in the following sequence:
D1->D2->D3->D4->D5->D1.
The higher the number, the more rinse aid the dishwasher uses.
4.Without operation in 5 seconds or press the Power button to exit the set
model, the set success.
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
- 24-
Publicité
