Publicité
Les langues disponibles
Les langues disponibles
FRANÇAIS
PROGRAM COOKING MODE
The PROGRAM COOKING mode allows you to program up to 3 cooking temperature and time settings
to create different stages of cooking. This mode can be used with or without the temperature probe.
1.
If using the TEMPERATURE PROBE, install as described above.
2.
For Stage 1, touch the PROGRAM COOKING symbol.
3.
Set your desired temperature by adjusting the CONTROL KNOB.
4.
Touch the PROGRAM COOKING symbol again.
5.
Set your desired time. A maximum of 480-minutes (8 hours) is possible when using the
TEMPERATURE PROBE mode and operating between 100º- 250ºF. For safety only 180-minutes is
available when operating between 275º-450ºF.
6.
Repeat these instructions for program Stage 2 and Stage 3. NOTE: each stage must be
programed within 5 seconds or the previous setting will be locked in.
7.
After all programs have been set the LCD display will cycle through all of the settings. After they
are locked in no further adjustments may be made. To reset, power off the unit and re-program
as needed.
TIMER
The Timer is adjustable in 1-minute increments. Please see instructions within each Operation Mode
for instructions on how to use. NOTE: Monitor cooking frequently when using the timer to avoid
boiling-over, over cooking, and damage to the unit or property.
CARE AND MAINTENANCE
•
Do Not clean with metal scouring pads, abrasives, or solvents
•
Do Not immerse cord or unit in water or other liquids
•
Unplug when not in use and before cleaning
•
Allow unit to cool before storing
•
Do Not use if glass cooktop or power cord is damaged
•
Keep away from other sources of heat
•
Unplug and let cool before cleaning. Use a mild liquid detergent with a moist cloth to wipe off
grease and stains. Let dry. Cover the unit to protect it from dust when being stored.
•
Clean the TEMPERATURE PROBE after use and place it in the PROBE STORAGE area.
TROUBLESHOOTING GUIDE & CUSTOMER SERVICE
If after reviewing the troubleshooting guide the problem is not resolved, do not attempt to repair.
Contact your dealer or call our Customer Service Department at 1-800-227-0196 for additional
information.
1.
The Power Indicator light does not illuminate and/or the exhaust fan is not running.
•
The power plug may be loose in the electrical outlet or there might be a 120V power
supply fault. Reset the circuit breaker and retry.
•
E3 error code means the 220V input power supply is too high or too low voltage and
shuts down after one minute. Unplug from the power receptacle and use a voltage sensor
to verify that the voltage is at least 220V AC and not more than 250V AC. If not, switch
electrical outlets or correct before operating the unit.
•
The fuse or circuit breaker has malfunctioned or the unit is unplugged.
2.
The fan is not running and the cookware is not heating up. E0 or E2 error code may be displayed.
•
The cookware may be unsuitable and it is preventing operation (see Selecting the Proper
Cookware). If no cookware is present an E0 code will show.
•
The cookware needs to be centered on the glass plate
•
The glass plate may be cracked
3.
The induction cooktop suddenly stops heating during operation and shuts down. E1 or E2 error
code may be displayed.
7
Publicité
