Beamz S500PC Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts
appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In
the event that a smoke machine must be returned to the factory, it is important that the smoke machine be returned in the
original factory box and packing.
If the smoke machine has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on
immediately. The arising condensation water might damage your device. Leave the device switched off until it has reached
room temperature.
POWERSUPPLY
On the label on the backside of the smoke machine is indicated on this type of power supply must be connected. Check that the
mains voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The smoke
machine must also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the smoke machine to a protected circuit (circuit breaker or fuse). Make sure the smoke machine has
an appropriate electrical ground to avoid the risk of electrocution or fire.
INSTALLATION
Attention:

When smoke machine has a built-in fluid tank, then should be transport and operated in an upright position.

Use only Beamz water-based fluid recommended by your dealer. Poor liquid caused permanent damage, bad effect,
clogging, spitting of unevaporated liquid etc.

Be sure that the smoke machine is positioned on a stable, non-slip surface.

Be sure that no ventilation slots on the product's housing are blocked.

Don't put any objects on the smoke machine.

Always install the smoke machine in an area with adequate ventilation.

Never connect the smoke machine to a dimmer or rheostat.

In the event of a serious operating problem, stop using the product immediately.

When mounted at height, use the bracket and use add a safety cable.

The installation of the smoke machine has to be built and constructed in a way that it can hold 10 times the weight for 1
hour without any harming deformation.

The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.

Never aim the smoke at yourself, people or animals.

Never aim the output nozzle directly at people or at open flames.

The smoke machine has to be installed out of the reach of people and animals

Drain the tank before transporting or storing the product.

Never drink smoke fluid or use it on the inside or outside of a human body. If fluid gets in contact with skin or eyes,
rinse thoroughly with water and call a doctor immediately!

Keep out of the reach of children.

For indoor use only.
4
CAUTION: Please consider the respective national norms during the
installation! The installation must only be carried out by an
authorized employee or dealers!
CAUTION: When installing the smoke machine, make sure there is no highly
in inflammable material (decoration articles, etc.) in between a
distance of min. 20in or 0.5 meter.
.