LENCO CR-510 Guide D'utilisation page 9

RADIO MODE
1. Press [AL. OFF/POWER] button turn on the unit, the "FM" is the default mode
2. Manual searching: short press [HOUR/SKIP-] button or [MIN/SKIP+] button can manual
adjust the FM stations
3. Auto-searching: press and hold the [HOUR/SKIP-] button or [MIN/SKIP+] button can auto
adjust the FM stations
4. Memory obtain the stations: short press [CLOCK/MEM.] button to callout the pre-set
station, the display will show "P01", press [CLOCK/MEM.] button again can callout the next
pre-set station, also you can press [HOUR/SKIP-] button or [MIN/SKIP+] button select the
pre-set stations. The display will show station frequency 5 seconds later, will exit the time
display if not press any buttons for 5 seconds
5. Storage the stations: select the station which you need stored, press and hold
[CLOCK/MEM.] button for 2-3 seconds, "P01" on LED display will blinking, press
[HOUR/SKIP-] button or [MIN/SKIP+] button to select the stored position, press
[CLOCK/MEM.] button to confirm
AUTO POWER OFF (SLEEP MODE)
Under power on mode, press [SNOOZE/SLEEP] button, LED will show "10", you can
continued press [SNOOZE/SLEEP] button to select sleep time from
"10→20→30→40→50→60→70→80→90→OFF", 5 seconds after you set the sleep time, will
auto confirm the set and activate the AUTO POWER OFF function. If you need power off
midway, press the [AL. OFF/POWER] button; check or change the auto power off time, after
activate the auto power off function, press [SNOOZE/SLEEP] button again, the LED will show
the rest auto power off time, press [SNOOZE/SLEEP] button again can select the next level
auto power off time (Such as: if originally you set "30", after 2 minutes, you check the LED
will show the rest 28 minutes, if you press [SNOOZE/SLEEP] button again, at this time, the
auto power off time will become "40"). If you need turn off the auto power off function,
repeat press [SNOOZE/SLEEP] button, until the LED show "OFF"
VOLUME CONTROL
Press [AL.1/VOL-] button or [AL2/VOL+] button adjust to your desired volume, the volume
have total "0-16" levels, the default volume is 10 level
TIME BACKUP
Install 2 pcs AAA 1, 5V batteries. In case of power failure the clock time will continue.
If no backup batteries are inserted the time will recover to a blinking "12:00" or "0:00" after power
failure.
9