Moulinex JU370810 Mode D'emploi page 32

CAUTION: the safety precautions are part of the
appliance. Read them carefully before using your
new appliance for the first time. Keep them in a
place where you can find and refer to them later on.
DESCRIPTION
A Pusher
B Feeding tube
C Cover
D Sieve
E Juice collector
F Pouring spout
SAFETY SYSTEM
To start the juicer, the cover (C) must be fitted correctly (Fig. 3) and the clamps properly locked
(Fig. 5).
At the end of a cycle, turn the control button to "0" and wait until the sieve (D) stops completely
before removing the cover (C).
BEFORE FIRST USE
We recommend that you wash the removable parts (A, B, C, D, E, F, G) before the first use (see
section "Cleaning and care").
Unpack the appliance and then place it on a solid, stable worktop, remove the cover (C) and take
out the protective card on the sieve (D).
USING THE APPLIANCE
• Place the juice collector (E) on the body of the appliance (see Fig. 2).
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is properly clipped onto
the drive shaft (K) (see Fig. 2).
• Fit the cover (C) on the appliance in order to have the pulp evacuation exit to the rear (see
Fig. 4).
• Lock the two handles (H) on the cover (C). You will hear an audible "click" (see Fig. 5).
• Slide the pusher (A) into the feeding tube (B) aligning the groove on the pusher with the
small ridge in the feeding tube.
• Place a glass under the pouring spout (F) in front of the appliance (see Fig. 6).
• Plug in the appliance.
• To start the appliance, use the control button (I).
• Cut the fruits or vegetables into pieces if necessary after removing the seeds.
32
G Pulp container
H Locking Handles
I Control button
J Motor unit
K Drive shaft
L Anti-slip feet