Hilti NURON AG 6D-22-6 Mode D'emploi page 16

ATC has tripped, switch the product off and then on again.
If
3D
3.5 SensTech function
This product is equipped with Hilti SensTech functionality. There are proximity sensors located in regions (1)
and (2) above which detect when a user's hand is in contact with the tool body. The user must fully and firmly
grip the tool body ensuring that at least one of the sensor regions is covered. If the user's hand is removed
or not enclosing a sensor region, the product will not turn on and if in operation will automatically shut-off.
The Hilti SensTech functionality is an electrical capacitance-based system and is not meant to replace
proper use or the safety instructions provided herein. Always ensure the gripping areas are free of liquid, dirt,
and other conductive / capacitive materials (i.e. metal shavings) prior to use. These conductive materials
may impair the SensTech functionality or render it inactive.
If the SensTech has tripped, switch the product off and on again.
3.6 Motor protection function
The motor protection function monitors current consumption and motor temperature and prevents the
product from overheating.
If the motor is overloaded through application of excessive working pressure, the product's performance
drops noticeably or it might stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the
product and then allow it to run under no load for approx. 30 seconds.
3.7 Integrated brake
The integrated brake reduces the time it takes until the accessory tool stops rotating after switching off.
This functions correctly only as long as the product is supplied with electric current.
Braking time varies, depending on the selected accessory tool.
3.8 Front cover 3
Use the standard guard with front cover for the applications listed below:
• Grinding with straight grinding discs
• Cutting with cut-off wheels
3.9 DG-EX 125/5" dust hood for grinding (accessory)
The grinding system is suitable only for occasional use with diamond cup wheels for grinding mineral
materials.
Use of this guard for working on metal is not permissible.
The dust hood is suitable only for accessory tools with a diameter of max. 125 mm (5").
3.10 DC-EX 125/5"M dust hood for cutting (accessory)
The power tool may be used for cutting and slitting work on mineral materials only when fitted with a dust hood.
Use of this guard for working on metal is not permissible.
The dust hood is suitable only for accessory tools with a diameter of max. 125 mm (5").
3.11 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
10 English
2
4
5
2282187
*2282187*