Hilti NURON AG 6D-22-6 Mode D'emploi page 14

▶ Tighten the accessory tool and flange securely. If the accessory tool and flange are not tightened
securely, the accessory tool may work loose from the arbor due to the braking effect of the motor after
switching off.
▶ Do not attach a belt hook to this product.
Electrical safety
▶ Before beginning work, check the working area for concealed electric cables or gas and water pipes.
External metal parts of the product could give you an electric shock or cause an explosion if you
accidentally damage an electric cable or a gas or water pipe.
▶ Dirty or dusty products that have been used frequently for work on conductive materials should be
checked at regular intervals by Hilti Service. Dust (especially dust from conductive materials) or
dampness adhering to the surface of the power tool may, under unfavorable conditions, lead to electric
shock.
Workplace
▶ Apply appropriate safety measures at the opposite side of the workpiece in work that involves breaking
through. Pieces of debris could drop out and / or fall down and injure other persons.
▶ Slits cut in load-bearing walls of buildings or other structures may influence the statics of the structure,
especially when steel reinforcing bars or load-bearing components are cut through.
responsible structural engineer, architect or person in charge of the building project before beginning the
work.
Additional notes on the use of the guards
To avoid the risks below always use the correct guard, see the section headed: "Suitability of wheels for the
equipment used".
▶ If the Standard guard with front cover is used for surface grinding, the guard can touch the workpiece
and thus lead to loss of control.
▶ If a wire brush of a thickness exceeding the maximum permissible thickness is used, the wires can snag
on the guard and break.
▶ If the standard guard is used for cutting off metal with an abrasive cut-off wheel, there is an increased
risk of exposure to sparks and particles and to wheel fragments if the wheel breaks.
▶ If the standard guard is used with or without front cover for cutting or for grinding concrete or masonry,
there is a higher dust load and an increased risk of losing control of the product, which can lead to
kickbacks.
8 English 2282187
*2282187*
Consult the