Genie S-105CD Mode D'emploi page 11

material is then collected in a separate tray thereby facilitating its environmentally-
friendly disposal.
Insert credit card:
1. Open the security door on the CD / credit card input opening.
2. Insert the card into the top center of the CD / credit card input opening. You can only
cut up one credit card at the time. Do this always ahead with the broad side into the
CD / credit card input opening. Otherwise, the magnetic strip is not destroyed.
Insert CDs:
1. Insert the CD centrally from above into the CD / credit card input opening. You can
only cut just one CD.
2. Do not insert your finger into the central hole of the disc when you insert it
into the device, there is danger of injury!
Protection against paper jams and overloading:
The S-105CD is equipped with a motor overload guard. To protect the machine well,
we suggest the user to operate it in this way: work 2 minutes then rest 60 minutes.
Under the following conditions, the current feed to the unit's motor is interrupted:
1. Continual operation of the document shredder with maximum capacity for a
prolonged period of time, e.g. longer than 2 minutes without interruption.
2. Overrunning the shredding capacity e.g. adding more than 5 sheets of paper (80g)
in one operation or in the event the paper is not inserted length-wise into the feed
slot.
Under the above-mentioned conditions, the automatic overload guard of the motor is
triggered, whereupon the current feed to the device is interrupted. In such a case,
please take the following steps:
1. Disconnect the main plug from the AC socket in order to avoid the risk of serious
injuries and wait at least 60 minutes until the overload guard has reset. Now tear
off excess paper from the top of the shredder or remove it.
2. Reconnect the main plug to the AC socket and set the switch to the REV position.
Pull the remaining paper away from the shredding blades. Afterwards, set the
switch back to the AUTO position. If necessary, repeat this step.
3. With the switch in the AUTO position and the open feed slot, you may now continue
the normal shredding process.
Technical data:
- 11 -