CASO DESIGN WineChef Pro 40 black Mode D'emploi page 32

12.5.2 Feet
You can adjust the height of the
device with the adjustable feet:
Please note
► You can reach the maximum
height of the device of 875 mm by
unscrewing the adjustable feet as
far as possible. Secure the nuts
with an open-end wrench.
► For the minimum height of the
device of 820 mm, remove the nuts
from the adjustable feet and screw
them in completely.
1. Measure the height of the niche in
which the device is to be placed.
2. Tilt the device forward slightly.
Adjust the height of the device with the
rear adjustable feet.
3. Tilt the device back slightly. Adjust
the height of the device with the front
adjustable feet.
4. Place the device at the installation
site without any lateral pressure.
5. Tilt the device back slightly and then use the front feet to adjust the device.
12.5.3 The installation of the handle
The wine cooler comes with one metal
stainless steel handle. To install simply
screw them to the door with the supplied
screws.
To do this, slide the rubber seal on the
back of the door to the side to lay open
the predrilled holes. Use the included
screws to install the handle on the door.
32