Torin BIG RED T82002 Manuel Du Propriétaire page 3

ASSEMBLY
1. Familiarize yourself with the jack.
Cover Plate
Handle
Pump Plunger
Rear Swivel
Casters
SYSTEM AIR PURGE PROCEDURE
IMPORTANT: BEFORE FIRST USE
Perform the following System Air Purge Procedure to remove any air that may have been introduced into
the hydraulic system as a result of product shipment and handling. This step is to be completed without any
weight on the jack.
1. Turn release valve counterclockwise one full turn
to the open position.
2. Remove cover plate.
3. Rapidly pump the handle 6-8 times. Leave handle
in down position to expose oil fill plug.
4. With a flat blade screwdriver, push the oil fill plug
slightly to the side to purge trapped air from
system. (Use caution not to tear or puncture the
oil plug.)
Lifting Arm
Saddle
Front Wheel
2. Line up the bottom of handle to the release valve
located under the handle socket. Turn handle and
release valve Clockwise to Tighten.
3. Secure the handle in place inside the handle
socket. Without any vehicle on the jack. Cycle
the lift up and down several times to insure the
hydraulic system is operating properly. (Perform
the System Air Purge Procedure before first use.)
5. Replace cover plate and the jack is now ready for
use. Check for proper pump action.
6. Turn release valve clockwise to the closed
position.
7. Jack is now ready for use. Check for proper pump
action. (Repeat steps if neccessary).
3
Oil Fill Plug
Screwdriver