Publicité
Les langues disponibles
Les langues disponibles
Problem
A layer of frost occurs in food is placed within the appliance to allow sufficient
the compartment
lemperatura inside is
too warm
Temperatura inside is
too cold
Doors cant be closed
easily
Water drips on the floor
The light is not working
FAULT DISPLAY
Fault display shows as following under Fault mode:
ERRORCODE
uc
RS
ES
FS
Fd
FF
FH
Possible cause & Solution
Check that the air outlets are not blocked by food and ensura
ventilation. Ensura that door is fully closed. To ramove the
frost, please refer to cleaning and care chapter.
You may have left the doors open too long or too fraquently; or
the doors are kept open by sorne obstacle; or the appliance is
located with insufficient clearance at the sides, back and top
lncrease the temperatura by following the "Display controls
chapter.
Check whether the top of the rafrigerator is tilted back by
10-15mm to allow the doors to self close, or if something inside
is praventing the doors from closing.
The water pan (located at the raar bottom of the cabinet) may
not be properly leveled, or the draining spout
undemeath the top of the comprassor depot)
properly positioned to diract water into this pan, or the water
spout is blocked. You may need to pull the refrigerator away
from the wall to check the pan and spout.
•The LED light may be damaged. Refer to raplace LED lights
in cleaning and cara chapter.
• The control system has disabled the lights due to the door
being kept open too long, close and reopens the door to
raactivate the lights.
Communication failura
Sensor failure (refrigerating chamber)
Failure of ambient temperatura sensor
Sensor failura (freezing chamber)
'
Defrosting sensor failura
16
ERRORTYPE
Fan failure
Defrosting failura
ª
( located
may not be
V.3
Publicité
