Hansgrohe Mondaro 18033 Serie Mode D'emploi page 7

Assembly
1. Flush through the supply pipes.
2. Place the spout including the sealing washer in
position on the basin/bidet.
3. Mondaro:Slip the slide washer, washer and
collar nut over the threaded base and tighten the
collar nut by hand.
Carlton:Slip the fixation piece including the was-
her over the threaded pin and tighten the nut.
4. Align spout and tighten screws.
5. Push valves with collar nut, washer and slide
washer from downward through the holes. Tighten
upper nut firmly. Align valves according to drawing.
Tighten collar nut by hand and tighten screws.
6. Mondaro: Screw hoses firmly into diverter.
Connect diverter together with hoses to the
waterinlet of the spout.
7. Connect hoses to the valves (see drawing).
8. Connect the supply pipes to the valves and tighten
it by hand; cold right - hot left
9. Mondaro: Place adapter piece for handle onto
valves and and fix them with screws. Screw flanges
onto valves and mount the handles.
Carlton: Place handles with flanges onto valves
and screw on flanges.
10. Push pull-rod from above through the spout and
connect it to the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
English
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 3a) located behind the mousseur must
be removed.
Spare parts
1
2
3
4
5
5.1 diverter knob
5.2 pull rod
6
7
8
9
10
11
12
13
14
14.1 diverter knob
14.2 pull rod
15
XXX = Colors Mondaro
000 chrome
010 chrom / gold / jewel
7 l/min 3 bars
090 chrome / gold
14 l/min 3 bars
490 white / gold
max. 10 bars
840 fine brass
1 - 5 bars
16 bars
XXX = Colors Carlton
max. 80° C
65° C
000 chrome
090 chrome / gold
810 satinox
840 fine brass
handle for cold water
handle for hot water
aerator cpl.
aerator gold plated
aerator fine brass
shut off unit, Elastop
pop up rod
fixation set
connection hose 350 mm
connection hose 450 mm
escutcheon for handle
handle for cold water
handle for hot water
escutcheon for handle
spout
pop up rod
fixation set
17291XXX
17292XXX
13085000
94980990
94980840
94149000
94028XXX
94086XXX
94085000
94138000
13099000
94071000
94035XXX
18291XXX
18292XXX
94115XXX
95030XXX
92621XXX
94066XXX
94069000
94702000