Publicité
Les langues disponibles
Les langues disponibles
Fig. 12
Dethatcher
cylinder with
spring metal tines
Scarifying
cylinder with
blades
m
WARNING!
Before performing any maintenance, always
disconnect the power supply to the unit and wait until the tine
cylinder comes to a complete stop. Wear protective gloves
when handling the tines.
1. Remove the thatch collection bag.
2. Place the machine upside down on a flat stable surface to
access the underbody.
3. Loosen the two locking bolts with the provided hex key
wrench, remove them together with the attached cutting
device (Fig. 13).
4. To remove the cutting device, first lift the bearing seat and
then pull it out from the drive shaft.
5. Align and insert the respective cutting device: Slide the
hex nut into the socket of the drive shaft and fix the
bearing seat to the support with the locking bolts (Fig. 14).
Locking bolt
Bearing seat
Scarifying cylinder
Fig. 13
Bearing seat
m
WARNING!
Make sure the cutting device (dethatcher
cylinder) is inserted properly. Make sure the semi-circle on the
bearing seat of the cylinder goes downward into the unit. If the
semi-circle is face up, it has been inserted incorrectly (Fig. 15).
Fig. 15
NOTE: If you have any questions, please call the Snow Joe
+ Sun Joe
customer service center at 1-866-766-9563
®
(1-866-SNOWJOE) for assistance.
After Use
1. Switch the machine off, disconnect it from the power
supply and let it cool down.
2. Check, clean and store the machine as described below.
Cleaning and Storage
1. Clean the exterior of the machine thoroughly using a soft
brush and cloth before storing. Do not use water, solvents,
or polishes.
2. Turn the scarifier + dethatcher on its side to clean the
cylinder area.
12
Hex nut
Socket
Fig. 14
Semi-circle
®
Publicité
