Télécharger Imprimer la page

EarthWise LSW70021 Manuel De Montage page 19

Masquer les pouces Voir aussi pour LSW70021:

Publicité

Les langues disponibles

Les langues disponibles

Fig. 9
Extension cord
restraint holder
Extension cord
Starting + Stopping
m
WARNING!
Before switching on the lawn scarifier +
dethatcher, make sure that it is not in contact with any foreign
objects. Keep your feet and hands a safe distance away from
the rotating tines and the ejector opening. Failure to comply
with these warnings can result in severe personal injury.
1. To start, press and hold the safety lock button while
pulling the switch lever toward you. Once the machine
powers on, release the safety lock button and proceed
with operation (Fig. 10).
Fig. 10
2. To stop the lawn scarifier + dethatcher, release the switch
lever.
m
WARNING!
The tine cylinder continues to run for a
brief period after the unit has been switched off. Do not tilt or
carry the unit while the motor is still running and do not touch
the cylinder while it is still rotating. Failure to comply could
result in severe personal injury.
Overload Protection
The overload protection will be activated in the following
circumstances:
1. A build up of scarified material around the cutting device.
2. If the material scarified is larger than the motor capacity.
3. Where there is too much resistance against the cutting
When the circuit breaker has been activated switch off the
product and disconnect from the power supply.
Let the product cool down and eliminate the cause before
using the product again.
General Operation
m
the motor. Switch the product off, disconnect it from the power
supply and let it cool down. Inspect the product thoroughly for
damage. Have any damage repaired before restarting.
m
operation is an indication of damage. The product should be
promptly inspected and repaired.
• Check the machine, its power cord and plug as well as
• Double check that accessories are properly fixed.
• Push the machine forward by its handle. Keep the handle
Switch lever
• Ensure that the air vents are always unobstructed and
Safety lock
button
• Switch the machine off immediately if you are disturbed
• Do not overwork yourself. Take regular breaks to ensure
• Mow the lawn before working and fertilize afterwards.
• Make sure that the lawn is clear of stones, sticks, wire, or
• Select the suitable cutting depth for the actual grass
• Do not work with this machine on a wet lawn because it
• Slowly push the machine forward. Move the machine at
10
device.
WARNING!
If the product strikes a foreign object stop
WARNING!
Extensive vibration of the product during
accessories for damage before each use. Do not use the
machine if it is damaged or shows wear.
dry to ensure safe support.
clear. Clean them if necessary with a soft brush. Blocked
air vents may lead to overheating and damage the
product.
while working by other people entering the working area.
Always let the machine come to complete stop before
putting it down.
you can concentrate on the work and have full control
over the machine.
other objects that could damage the machine or its motor.
height.
tends to stick to the underbody of the machine, preventing
the proper discharge of collected material, and it could
also cause you to slip and fall.
appropriate speed. Do not move it too fast to prevent the
discharge from getting blocked and engine from useless
overloading.

Publicité

loading