Publicité
Les langues disponibles
Les langues disponibles
Attach the thatch collection bag to the lawn scarifier +
dethatcher before operation.
1. Lift the ejector flap, and hang the thatch collection bag to
the mounting hooks (Fig. 7).
Fig. 7
Removing + Emptying the Thatch
Collection Bag
Empty the thatch collection bag frequently during use. Do not
wait until it is completely full. We recommend emptying it when
it is half full.
1. Lift the ejector flap and pull the thatch collection bag off
the mounting hooks to remove it.
2. Empty the bag's contents into a suitable waste receptacle.
Mount the bag back into position before resuming work.
Intended Use
1. This scarifier + dethatcher is designated with a 13 amp
motor. Depending on the fitted cutting device, this
machine is either intended for scarifying and removing
thatch from lawns or raking in domestic and hobby
gardens.
2. When used as a scarifier, this machine works by
scratching through and between the grass with specially
adapted prongs that collect and remove any unwanted
parts from the lawn while leaving the grass blades intact.
At the same time the machine scarifies the ground
resulting in a better aeration.
3. When used as a dethatcher the fine needles will scratch the
surface of the lawn while simultaneously picking up light
debris for better oxygen absorption, airing and drainage.
4. This machine is not to be used in wet weather conditions
and may not be used to mow dry, wet or unusually high
grass, e.g., pasture grass or for shredding leaves.
5. This machine is intended for private domestic use only,
not for any commercial trade use. It must not be used for
any purposes other than those described.
Ejector flap
R
Mounting hook
Operation
Cutting Depth Adjustment
m
WARNING!
The unit must be switched off and
disconnected from the power supply before adjusting the
tine settings.
Adjust the depth according to the needs of your lawn. The
most suitable depth depends on the kind of lawn and the
actual height of the grass.
1. Pull the depth adjustment lever away from the wheel, then
move it forward or backward to adjust the cutting depth
(Fig. 8).
Fig. 8
Pull out
2. Adjust the lever to one out of the five stages. Read the
adjusted depth from the scale.
Setting
Depth
High
10 mm
Minimal
5 mm
Middle
0 mm
Deep
-5 mm
Deep
-10 mm
Power Connection
Push a loop of the extension cord through the slot on the
extension cord restraint holder from the opposite side of the
restraint holder (Fig. 9). Insert the appliance cord into a proper
outdoor extension cord (see Extension Cord Chart on page 2).
9
Adjust
Depth adjustment
lever
Application
For pushing behind with the
machine; and removing thin
thatch layers. Do not use for
scarifying.
For raking healthy lawn. Do not
use for scarifying.
For transport, storage, scarifying
and raking.
For scarifying, not
recommended for raking.
For scarifying, do not use
for raking.
Publicité
