Publicité
Les langues disponibles
Les langues disponibles
CONNECTING THE APPLIANCE TO THE
POWER SUPPLY
28
2 - ZANUSSI_EN230_20LSOLO_SBI_BASE_AE31UICTO.indd 28
2 - ZANUSSI_EN230_20LSOLO_SBI_BASE_AE31UICTO.indd 28
(A)
•
The electrical outlet should be readily
accessible so that the unit can be unplugged
easily in an emergency. Or it should be
possible to isolate the oven from the supply
by incorporating a switch in the fixed wiring in
accordance with the wiring rules.
•
The power supply cord may only be replaced
by an electrician.
•
If the supply cord is damaged it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
•
The socket should not be positioned behind the
cupboard.
•
The best position is above the cupboard, see
(A).
•
Connect the appliance to a single phase
230 V/50 Hz alternating current via a correctly
installed earth socket. The socket must be
fused with a 10 A fuse.
•
Before installing, tie a piece of string to the
power supply cord to facilitate connection to
point (A) when the appliance is being installed.
•
When inserting the appliance into the high-
sided cupboard, DO NOT crush the power
supply cord.
•
Do not immerse the power supply cord or plug
in water or any other liquid.
•
Do not allow the power supply cord to run over
any hot or sharp surfaces, such as the hot air
vent area at the top rear of the oven.
12/06/2023 08:37:54
12/06/2023 08:37:54
Publicité
