SilverCrest SV 125 C6 Mode D'emploi page 15

Vacuum sealing
Vacuuming the tube film
You can also suck the air out of the bag (vacuum) during welding:
NOTE
► Do not try to vacuum seal bags that contain only liquids.
► If you want to vacuum seal bags containing moist/juicy foods, make sure
that no water or moisture can get into the appliance. If small quantities
of liquid or food are accidentally sucked in, they will be deposited in the
small drip tray that is located within the lower sealing ring 5.
1) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5. The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7. Otherwise the vacuuming and welding will not function correctly:
2) Close the appliance lid 1. Ensure that both corners of the appliance lid 1
click closed. If necessary, press them down once again on the markings
and
■ 12 │ GB │ IE
so that the appliance lid 1 clicks into place and locks shut.
SV 125 C6