Bosch NIT5660UC Manuel D'utilisation page 15

Display Function
⁠ ⁠ Power management function. Limiting the to-
tal power of the cooktop. The available set-
tings depend on the maximum power of the
cooktop.
– Deactivated
– 1.000 W minimum power
– 1.500 W
...
– 3.000 W recommended for 13 A
. – 3.500 W recommended for 16 A
– 4.000 W
. – 4.500 W recommended for 20 A
...
or . – Maximum power of the cooktop
Time for setting a cooking zone after selec-
tion
– Unlimited: The last selected cooking zone
remains selected. You can adjust the settings
without having to select it again
– Limited: You can adjust the settings for
the selected cooking zone within 10 seconds.
After 10 seconds you have to select the
cooking zone again.
Results for suitability test for cookware
– Not suitable.
– Not ideal.
–Suitable.
Restore factory settings
– Off 1
– Restore appliance to factory settings
1
Factory setting
2
Factory setting (may vary according to model)
3
The cooktop's maximum power output is shown on the
rating plate
Changing the basic settings
Requirement: The cooktop is turned off.
Turn on the cooktop.
1.
Within the next 10 seconds, press Timer for about
2.
4 seconds.
The first four displays provide the product information.
To call up the individual displays, touch the control
panel.
Product information
Customer Support index (CI)
Production number
Production number 1
Production number 2
2 , 3
3
1
.
Display
⁠ .
Press Timer to access the basic settings.
3.
a In the left display and flash alternately.
a In the timer display lights up.
Press Timer repeatedly until the desired setting lights
4.
up in the left display.
Set the desired option in the settings area.
5.
Press Timer for about 4 seconds.
6.
a The setting is saved.
Tip: Press On/Off to leave the basic settings and turn off
the cooktop.
6.10 Power limitation
You can use the PowerManager function to set the total
power of the cooktop.
The cooktop is set at the factory; the cooktop's maximum
power is shown on the rating label. You can use this func-
tion to adjust the configuration to the requirements of each
electrical installation.
In order to not exceed this set value, the cooktop automat-
ically distributes the available power as needed between
the cooking zones that are switched on.
While this function is activated, the output of each cooking
zone may temporarily fall below the nominal value. In or-
der to not exceed this set value, the cooktop automatically
distributes the available power as needed between the
cooking zones that are switched on . The appliance regu-
lates and selects the highest power level automatically.
For more information, go to
→ "Basic settings", Page 14
Operation en-us
15