Sharp PN-V602A Manuel D'installation page 5

SAFETY PRECAUTIONS (Continued)
21. Do not stay in contact with the parts of the product that become hot for long periods of time. Doing so may result in
low-temperature burns.
22. Do not modify this product.
WARNING:
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
To maintain compliance with EMC regulations, use shielded cables to connect to the following terminals: PC/AV DVI-D output
terminal, PC/AV DVI-D input terminal, PC/AV HDMI input terminal, PC D-SUB input terminal, PC RGB input terminals, and
RS-232C input/output terminals.
If a monitor is not positioned in a sufficiently stable location, it can be potentially hazardous due to falling. Many injuries,
particularly to children, can be avoided by taking simple precautions such as:
• Using fixing devices like wall mount brackets recommended by the manufacturer.
• Only using furniture that can safely support the monitor.
• Ensuring the monitor is not overhanging the edge of the supporting furniture.
• N ot placing the monitor on tall furniture (for example, cupboards or bookcases) without anchoring both the furniture and the
monitor to a suitable support.
• Not standing the monitors on cloth or other materials placed between the monitor and supporting furniture.
• Educating children about the dangers of climbing on furniture to reach the monitor or its controls.
• This equipment is not suitable for use in locations where children are likely to be present unsupervised.
Especially for child safety
- Don't allow children to climb on or play with the monitor.
- Don't place the monitor on furniture that can easily be used as steps, such as a chest of drawers.
- R emember that children can become excited while watching a program, especially on a "larger than life" monitor. Care
should be taken to place or install the monitor where it cannot be pushed, pulled over, or knocked down.
- C are should be taken to route all cords and cables connected to the monitor so that they cannot be pulled or grabbed by
curious children.
- D o not use the monitor where there is a lot of dust, where
humidity is high, or where the monitor may come into contact
with oil or steam. Do not use in an environment where
there are corrosive gases (sulfur dioxide, hydrogen sulfide,
nitrogen dioxide, chlorine, ammonia, ozone, etc.). As this
could lead to fire.
- E nsure that the monitor does not come into contact with
water or other fluids. Ensure that no objects such as paper
clips or pins enter the monitor as this could lead to fire or
electric shock.
- D o not place the monitor on top of unstable objects or in
unsafe places. Do not allow the monitor to receive strong
shocks or to strongly vibrate. Causing the monitor to fall or
topple over may damage it.
- D o not use the monitor near heating equipment or in places
where there is likelihood of high temperature, as this may
lead to generation of excessive heat and outbreak of fire.
- D o not use the monitor in places where it may be exposed to
direct sunlight. Risk of cabinet deformation and failure if the
monitor is used in direct sunlight.
- I f the monitor is installed in a location exposed to sunlight
such as next to a window, measures to reduce ultraviolet and
infrared radiation and temperature measures are required.
For details, consult your dealer.
- T he AC outlet shall be installed near the equipment and shall
be easily accessible.
SAFETY INSTRUCTION
The Power Cord
- Use only the power cord supplied with the monitor.
- D o not damage the power cord nor place heavy objects on
- D o not use the power cord with a power tap.
- D o not remove or insert the power plug with wet hands.
- Unplug the power cord if it is not used for a long time.
- D o not attempt to repair the power cord if it is broken
it, stretch it or over bend it. Also, do not add extension cords.
Damage to the cord may result in fire or electric shock.
Adding an extension cord may lead to fire as a result of
overheating.
Doing so could result in electric shock.
or malfunctioning. Refer the servicing to the service
representative.
3
E