Fcc Compliance Statement; Warranty - Beurer TL 50 Mode D'emploi

Light intensity
Radiation
Operating conditions
Storage conditions
Product classification
Color temperature
Power adapter manufacturer Mitra Power Solution Co. LTD;
Power adapter model
Power Adapter Input
Power Adapter Output
Polarity

10. FCC Compliance Statement

Changes or modifications to the product not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

11. Warranty

Limited Lifetime Warranty For Original Purchaser
Your Beurer daylight lamp, Model TL 50, is warranted to be free from defects in materials and workmanship for
the life of the product under normal conditions of intended use and service. This warranty extends only to the
original retail purchaser and does not extend to retailers or subsequent owners.
We will, at our option, repair or replace the Beurer daylight lamp , Model TL 50, without additional charge, for
any part or parts covered by these written warranties. No refunds will be given. Repair or replacement is our
only responsibility and your only remedy under this written warranty. If replacement parts for defective mate-
rials are not available, Beurer reserves the right to make product substitutions in lieu of repair or replacement.
For warranty service contact our customer service department at 1-800-536-0366 or at info@beurer.com to
provide a description of the problem. If the problem is deemed to be within the scope of the limited lifetime
warranty, you will be asked to mail the product at your costs in its original package with proof of purchase, your
name, address and phone number. If the problem is not deemed to be within the scope of the limited lifetime
warranty, we will provide a quotation for repair respectively replacement and return shipping fee.
This warranty does not cover damage caused by misuse or abuse; accident; the attachment of unauthorized
accessory; alteration to the product; improper installation; misapplication; lack of reasonable care with respect
to the product; unauthorized repairs or modifications; improper use of electrical/power supply; old worn bat-
teries; normal wear; loss of power; dropped product; malfunction or damage of an operating part as a result
of failure to comply with instructions for use or to provide manufacturer's recommended maintenance; transit
approx.10,000 lux (at a distance of 5.9 in / 15 cm)
Output of radiation beyond the visible spectrum (infrared and UV) is so low
that it is harmless to eyes and skin.
41° - 95° F (5° - 35° C), 15 - 90 % relative humidity
-4° - 122° F (-20° - 50° C), 15 - 90 % relative humidity
External power supply, Protection class II, IP21
5.300 K
MP45-240150-AU
100–240 VAC ~50/60 Hz
24 VDC, 1.5 A
Center Positive
6