Echo HC 500 Mode D'emploi page 13

Hedge Trimmer
Technical data
Operating Voltage
Nominal Frequency
Nominal Consumption
Cutting movements
Cutting length
Cutting capacity
Weight (without flex)
Noise Pressure Level L
Vibration according to 60745-1
Class of protection: II/DIN EN 60745/VDE 0740
Interference suppressed in accordance with EN 55014, EN 61000-3-2, EN 61000-3-3.
We reserve the right to make changes to the technical specifications.
The devices are manufactured in accordance with the provisions of EN 60745-1and EN 60745-2-15 and fully comply with
the provisions of the German Product Safety Act.
Emissions
- The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specified vibration emission value can also be necessary for the assessment of work breaks are used.
- The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks
- Try to keep the stress due to vibration as low as possible. For example, measures to reduce vibration stress are
wearing gloves when using the tool and limiting the work time. All phase of the operating cycle must be considered
in this regard, (for example, times when the power tool is switched off, and times when the power tool is switched
on but is not running under load).
The noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator will require noise
protection (e.g. wearing of ear protectors).
Attention: Noise protection! Please observe the local regulations when operating your device.
GB | Operating Instruction
according to EN 60745-1
pA
V AC~
Hz
W
-1
min
mm
mm
Kg
dB (A)
2
m/s
2
HC 500 Echo
230
50
500
2500
450
18
1,9
86,8
K=0,6 dB(A)
2,6
K=1,5 m/s²