Publicité
Les langues disponibles
Les langues disponibles
10. Installing and aligning the appliance
m
CAUTION
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
– Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
– The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
– Do not bend the appliance against the anti-tip-
angles.
Align the appliance with the furniture fronts.
Place marking-out level over the installation aid parts on
the door.
20
The installation aid parts on the door have been designed for
the following total thickness of furniture doors:
3
m
–
/
" (19 mm)
4
1
–
1
/
" (38 mm)
2
Always take account of the possible differing thickness of the
furniture fronts which are to be fitted subsequently.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front:
with open-ended wrench
Rear:
with
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1
the floor.
Unscrew the height-adjustable feet until the mark on
the base has reached the indicated guide dimension
1
(1
/
" / 32 mm).
4
It is very important to comply with this dimension
for the subsequent alignment of the furniture fronts.
Align the furniture fronts with the spirit level.
1
/
" (SW13)
2
5
/
" (8 mm) hex nut driver via flexible shaft.
16
1
/
" (32 mm) above
2
NOTE
Publicité
