Initial Setup; Telescopic Pole - Steamfast SF-147 Guide D'utilisation

Initial Setup

TELESCOPIC POLE

1. Connect Handle to upper, narrower end of Telescopic Pole.
To do this, simply slide Handle onto Telescopic Pole until
Release Button, located on Telescopic Pole, snaps through
small hole on Handle (Figure 1).
2. Insert lower, wider end of Telescopic Pole into Mop Body.
(Figure 2). Make sure Release Button, aligns with the small
hole on Mop Body. Press Telescopic Pole until Release But-
ton snaps through small hole on Mop Body. Telescopic Pole
should now be secured to Mop Body.
NOTE: In order to coax Release Button through hole, it may
be necessary to rotate and adjust Telescopic Pole until button
aligns properly with hole.
3. To adjust the height of Telescopic Pole, press and hold Ex-
tension Lock downward (Figure 3). While holding Extension
Lock down, move Telescopic Pole until it is adjusted to the
desired height. Release Extension Lock, then move Tele-
scopic Pole again until it "clicks" securely into place
(Figure 4).
4. To disconnect Telescopic Pole for storage, press firmly on
Release Button while simultaneously pulling Telescopic Pole
away from Mop Body.
8 English
Figure 1 Figure 2 Figure 3 Figure 4