Operation - Steamfast SF-147 Guide D'utilisation

How to Use

OPERATION

Before operating, make sure Microfiber Pad is properly at-
tached and Water Tank is filled with water.
NOTE: Refer to MOPPING RECOMMENDATIONS for tips on
recommended floor surfaces.
1. Unwrap Power Cord completely and plug into a 120V
grounded outlet.
2. Turn On by pressing Power Button located
on the front of Mop Body (A). The Power
Indicator Light will illuminate red when
power is On (B).
3. Place Resting Pad on floor, so that the textured side faces
upward. Rest Mop Head on top of Resting Pad, in order to
help protect the floor surface from excess heat and moisture
(Figure 1).
Figure 1
NOTE: Place the Everyday Steam Mop on the Resting Pad
12 English
while waiting for steam to start or when not in use.
After approximately 30 seconds of heat up time, the unit will
begin emitting steam. The unit is now ready for use. It is com-
mon to hear the water pump make a noise while it is producing
steam.
4. For best results, mop using a steady back-and-forth motion
over the floor, working your way backwards in order to avoid
walking over the freshly mopped area (Figure 2).
A
B
5. Once all water has been used, turn off the unit. If you wish
to continue mopping, place unit on Resting Pad and refill
Water Tank (refer to FILLING THE WATER TANK for instruc-
tions).
6. When finished mopping, place unit on Resting Pad and turn
unit Off by pressing Power Button. Unplug Power Cord from
outlet, then refer to STORAGE AND CARE.
±
Figure 2
±