Sanyo SPW-XDR74GXH56A Mode D'emploi page 17

OI-751-17-EG
Display
F B
J K D O G E
A: When the unit is in the heating standby mode, the
is displayed, the indoor fan turns off or on at low fan speed.
B: The currently selected operation mode is displayed.
* The SPW-DR764/964GXH56 (A/B) shows the dry indicator, but it does not have a dry
function.
C: This is displayed if a different operation mode was selected already by another remote
control unit and indicates that the mode cannot be changed.
D: After turning on the mains power switch for the first time,
display of the remote control unit. While this is displayed, the system is automatically
checking units, and so wait until the
unit. When the TIMER SET button is pressed to set the timer, the
E: The currently selected FAN SPEED, fan angle and SWEEP status are displayed.
F: This is displayed only if an abnormality occurs within a unit.
G: When the CHECK button is pressed for more than 4 seconds, the TEST indicator appears.
Then, press the ON/OFF operation button to start test run.
H: This is displayed to indicate that the system controller is being used for control. When
is flashing on the display, the operation is not accepted by the system controller.
I: This displays the unit number of the indoor unit selected with the unit selection button or the
indoor/outdoor unit where an error is indicated.
Unit No.
1 — 2
Indoor unit No.
Refrigerant circuit No.
J: This is displayed if it is time to clean the filter.
K: When setting the timer, the selected timer mode is displayed. This displays the time of the timer.
(An alarm message is displayed when an error occurs.) Pressing the TIMER SET button cycles
through the options in this order:
L: This is displayed when using the remote control unit sensor.
M: This is displayed if a function is unavailable when a button is pressed.
N: This displays the temperature setting.
O: This is displayed when a connected ventilation fan (available commercially) is operating.
C H
I M A
Description
indicator appears. While this indicator
indicator turns off to operate the remote control
N
L
indicator blinks on the
indicator flashes.
No Display
17