Publicité
Tapered Wall Jamb/Montant du mur conique/Jamba mural angular
Anchor/Ancrage/Anclaje
Wall/Mur/Pared
Pencil
Crayon à papier
Level
Lápiz
Niveau
Wall Jamb
à bulle
Montant du mur
Nivel
Jamba mural
Mark the Wall Jambs
Position a wall jamb against the wall directly over the bottom track with the
shorter leg facing out. The wall jamb should sit flat against the wall.
Position the tapered end against the base of the shower wall.
Slide the wall jamb down over the bottom track until the wall jamb and bottom
track are fully engaged.
IMPORTANT! The wall jamb must sit flat on the bottom ledge. If your ledge has a
curve in the corners at the side wall, it may be necessary to shape the bottom end of
the wall jamb with a file.
Use a level to plumb the wall jamb vertically.
Using the pre-drilled screw holes as a guide, mark the hole locations on the wall.
Repeat the procedures with the second wall jamb.
Remove the bottom track and wall jambs.
NOTE: When installing on ceramic tile, use a center punch to nick the surface of the
glaze. Tap the center punch lightly with a hammer to avoid cracking the tile.
Lightly center punch the hole locations.
Drill a 3/16" hole at each mark. Use a tile or masonry bit for ceramic tile.
Thoroughly clean the shower floor ledge and wall.
Insert plastic anchors in each hole.
Marquer les montants du mur
Placer un montant du mur contre le mur directement sur le rail inférieur avec le
pied le plus court vers l'extérieur. Le montant du mur devrait bien reposer à plat
contre le mur.
Positionner le côté conique contre la base du mur de douche.
Glisser le montant du mur sur le rail inférieur jusqu'à ce qu'ils soient
complètement engagés.
Sterling
Tapered Wall Jamb
Montant du mur conique
Jamba mural angular
Bottom Track
Rail inférieur
Carril inferior
Wall Anchor
Ancrage mural
Anclaje de pared
Tapered end down.
Extrémité conique vers le bas.
Lado angular hacia abajo.
Inside of Bath/Shower
Intérieur de baignoire/douche
Interior de la bañera/ducha
9
1063220-2-C
Publicité
