Publicité
Les langues disponibles
Les langues disponibles
Assembly Procedure
2) Fix with the 4 display installation screws
Tightening torque: 1.6 to 2.2 N•m
Note
● Do not install the display vertically using the pedestal.
3. Attaching the base
■
Base
● Position the convex part side at the front side of the
display.
1) Insert the base
to the pedestal tube.
● Make sure that the orientation of the front side and
back side of the base are correct.
● Be careful not to drop.
2) Fix the base
with 4 base installation screws
● Tighten the base installation screws from the outside
of the pedestal tube.
Tightening torque: 1.2 to 1.5 N•m
3) To stand the display vertically.
● When installing and removing the display from the
pedestal, two or more people are required when the
display weighs more than 25 kg. If more than 50 kg,
4 people are required.
(Please carefully follow all of the display installation
instructions.)
(Cont'd)
.
Front of the display
.
Display installation screw
Base installation screw
Convex part
Base
15
Publicité
