E. CLEARING: when setting modes and the specific mode symbol is blinking, press the "--" button for 5 seconds, it
can make "Single Cycling Distance", "Single Cycling Time" and "Top Speed" zero cleared (Note: the "Total
Distance" cannot be cleared out) (Fig. 15).
THIS PRODUCT MUST BE ASSEMBLED BY A PROFESSIONAL TECHNICIAN AND WHO IS NOT QUALIFIED TO DO SO MUST NOT TRY TO
ASSEMBLE IT.
7) Error indicator:
in the event of a system error, the error icon and the error code flash on the display.
Each code displayed represents a different type of fault.
Nomenclature of error codes:
CODE D'ERREUR
0
1
2
3
4
No anomalies
anomaly or damage of the MOS tube
anomaly change check (start-up detection)
3-phase dead motor
Hall signal anomaly
DEFINITION
29