Metabo HPT NV 65AN Manuel D'instructions Et De Sécurité page 20

English
Nail Guide
Nail Stopper
4 Lubricate the feeding surfaces of the nose and
the nail guide after cleaning.
This promotes smooth operation and prevents
rust.
CAUTION
● Check that the nail stopper slides smoothly by
pushing them with fi nger.
If not smooth, nails can be driven at an irregular
angle and hurt someone.
4. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove dust or wooden tips
which may have accumulated in the magazine.
5. Storing
○ When not in use for an extended period, apply a
thin coat of the lubricant to the steel parts to avoid
rust.
○ Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach children.
6. WARNING LABEL
Do not use the Nailer with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
20
Feed Piston
Feeder Shaft
Feeder
Warning
Label
7. Maintenance chart (See page 21)
8. Operator troubleshooting (See page 21)
9. Service parts list
CAUTION
● Repair, modifi cation
metabo HPT Power Tools must be carried out by
a metabo HPT Authorized Service Center.
This Parts List will be helpful if presented
with the tool to the metabo HPT Authorized
Service Center when requesting repair or other
maintenance. In the operation and maintenance
of power tools, the safety regulations and
standards prescribed in each country must be
observed.
MODIFICATIONS:
metabo HPT Power Tools are constantly being improved
and modifi ed to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without prior
notice.
SERVICE AND REPAIRS
● Only service
metabo HPT, distributor or employer shall
repair the Nailer.
● Use only parts supplied or recommended by
metabo HPT for repair.
All quality Nailers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE: Specifi cations are subject to change without any
obligation on the part of metabo HPT.
and inspection
WARNING
personnel trained
of
by