Publicité
Les langues disponibles
Les langues disponibles
Section
Tuner
04
Listening to the radio
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
1 Stereo (5) indicator
Shows that the frequency selected is being
broadcast in stereo.
2 Preset number indicator
Shows what preset has been selected.
3 Frequency indicator
Shows to which frequency the tuner is
tuned.
4 Signal level indicator
Shows the radio wave strength.
5 Band indicator
Shows which band the radio is tuned to, AM
or FM.
1
Press SOURCE to select the tuner.
Press SOURCE until you see TUNER dis-
played.
2
Use VOLUME to adjust the sound level.
Rotate to increase or decrease the volume.
3
Press BAND to select a band.
Press BAND until the desired band is dis-
played, F1, F2, F3 for FM or AM.
12
En
HHHHHHHHHHHHHH
All manuals and user guides at all-guides.com
1
2
5 4
3
4
To perform manual tuning, press c or
d with quick presses.
The frequencies move up or down step by
step.
5
To perform seek tuning, press and hold
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pressing either
c or d with a quick press.
# If you press and hold c or d you can skip
broadcasting stations. Seek tuning starts as soon
as you release the buttons.
Note
When the frequency selected is being broadcast
in stereo the stereo (5) indicator will light.
Publicité
