Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
optimal depth leaving approximately 7/32" (5.5 mm) of the
screw exposed. Align the slots on the back of the charger
with the exposed screws and fully engage them in the slots.
Versatrack
CRAFTSMAN chargers can be mounted to the wall using
CRAFTSMAN Versatrack Trackwall. Hooks and accessories
are sold separately. Please refer to the Versatrack Trackwall
accessory sheet for further information.
SAVE THESE
INSTRUCTIONS
FOR FUTURE USE
COMPONENTS (FIG. A)
Intended Use
This cordless handheld blower is designed for household
blowing applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
CAUTION:
before removing extension attachment or end
attachment. An attachment must be attached to the
housing before use.
Tube Assembly (Fig. A, B)
•
To attach the tube
4
to the blower, line up the pegs
on the bottom of the tube with the notch
bottom of the housing opening. Push the tube into the
blower housing until the lock engages the tube and an
audible click is heard.
•
Pull on the tube to ensure it is securely in place.
•
To remove the tube, insert a screwdriver into the
unlocking hole
9
on the side of the housing. Lift the tab
inside and pull tube out.
To reduce the risk of
Ensure the battery is removed
7
8
on the
Fig. B
7
OPERATION
WARNING:
without tube securely in place. Never reach down into
housing through tube hole.
WARNING:
when you leave blower unattended or when
storing,checking, adjusting, cleaning, or working
on blower.
Installing and Removing the Battery Pack
(Fig. C)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
5
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
6
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. C
6
5
English
8
9
Do not operate blower
Always remove the battery
into the tool handle, align the
7
Publicité
Table des Matières
