Publicité
Les langues disponibles
Les langues disponibles
2. DESCRIPTION
Body of the appliance
a
b Lid
c Water tank
d Water level indicator
e Carafe lid
f Carafe handle
g Carafe
h Warming plate
i Filter holder
j Permanent gold tone filter
k BREW/control knob
l CLOCK button
3. SETTING THE CLOCK
■ Place the coffee maker on a hard flat surface.
■ Connect the power cord to a 120V wall socket.
1 - When you connect the coffee maker for the first time, "1:00 pm" displays and flashes on screen. Fig. 1.
Program the time by turning the BREW/control knob (k) to the right to increase, to the left to decrease. Confirm
by pressing the CLOCK button (l) or the BREW/control knob (k). The time is displayed. Fig. 2 and 3.
2 - You may also program or change the time at any other time. Press the CLOCK button (l) and turn the BREW/
control knob (k). Set by pressing the CLOCK button (l) or the BREW/control knob (k). The time is displayed.
Note: Your clock is now programmed and will continue to display the time even when your appliance is on
standby.
If the appliance is disconnected or there is a power failure, the clock will return to 1:00 PM. The steps above
must be repeated to program the clock again.
4. BEFORE FIRST USE
■ Remove stickers from your coffee maker.
■ Before first use, run your coffee maker without coffee to flush the circuit. Fill the water tank up to the maximum
level and begin a cycle by pressing the BREW/control knob (k).
IMPORTANT : Your appliance was designed to operate only with cold or room temperature water.
5. MAKING COFFEE
■ Open the lid of the coffee maker (b). Fig. 4.
■ Fill the carafe (g) with cold or room temperature water. Pour the water in the water tank (c) Fig. 5. The
water level indicator displays the number of cups. Do not exceed 12 cups. Fig. 6.
■ Place the carafe (g) with its lid on the warming plate (h) making sure that it is properly placed to trigger the
mechanism that will allow the coffee to flow. Fig. 7.
■ It is best to remove the filter holder with the filter before adding the ground coffee. If ground coffee has
accidentally been poured into the water tank, please do not run the cycle; instead clean the water tank. The
ground coffee could plug the water circuit.
■ Add 1 KRUPS (v) spoonful of ground coffee per cup. Do not exceed 12 spoons (2 ounces). Fig. 10.
■ Make sure the filter holder (i) is inserted. Fig. 8. Place the permanent filter (j) in the filter holder (i) Fig.
9a or a No. 4 paper filter Fig. 9b. If you use a paper filter, be sure it is fully open and properly positioned
in the filter holder.
m REGULAR/ BOLD button
n 1-4 CUPS button
o CLEAN button
p AUTO ON button
q TURBO button
r Filter cartridge holder
s Filter cartridge
t Keep Warm TEMP Button
u Keep Warm TIME button
v Spoon
w Replacement indicator of the filter cartridge
x Aroma tube
9
Publicité
