Krups SAVOY EC415050 Mode D'emploi page 8

■ Close the lid (b).
■ Press the BREW/control knob (k). The control knob lights up to indicate that the coffee maker has begun
the BREW cycle. It beeps once when it starts brewing. Fig. 12.
■ When the cycle has ended, the 'keep warm' feature turns on automatically (the countdown showing the
time during which it will remain warm is displayed on screen). The BREW/control knob (k) flashes slowly.
■ After the default keep warm time of 2 hours your appliance beeps 3 times and the BREW/control knob
(k) switches off.
■ At any time during the brew cycle, you may turn off the coffee maker by pressing the BREW/control knob
(k). The light on the BREW/control knob will also go out. It beeps 3 times prior to turning off.
Even if the brew cycle has ended, there is still hot liquid in the filter. Wait a few minutes for the rest of the
liquid to flow into the carafe before removing the filter.
Note :
- The amount of coffee in the carafe at the end of the cycle is less than the amount of water poured into the
water tank, since the ground coffee and the filter absorb about 10% of it.
- The water tank is equipped with an overflow outlet at the rear of the appliance. If you add too much water,
it will come out of this opening.
- Clean the permanent filter in between each use, or use a paper filter.
- The tip Aroma Tube (x) of the carafe is removable. You can use your coffee maker without Aroma Tube.
CAUTION:
- To avoid overflowing, the carafe should be properly placed on the warming plate of the coffee
maker, otherwise the hot water or hot coffee may overflow.
- The coffee maker becomes very hot during the brew cycle. Handle it carefully.
6. OTHER FEATURES
6A – AUTO START FUNCTION
Programming the auto-start settings.
■ Your appliance is equipped with two auto-start programs.
■ Check whether the clock is set to the right time. If not, follow the instructions in the SETTING THE CLOCK
section.
■ Press the AUTO ON button. An AUTO 1 icon displays on screen. Fig. 13.
■ Turn the BREW/control knob (k) to set the time. Confirm by pressing the BREW/control knob (k). The time
is displayed. Fig. 14 and 15.
■ Without validation with the BREW/control knob (k), the time is recorded automatically after about 5
seconds.
■ To set the second program, push the AUTO ON button twice, so that the AUTO 2 icon appears on screen.
Fig. 16.
■ Turn the BREW/control knob (k) to set the time. Validate by pressing the BREW/control knob (k). The time
is displayed. Fig. 17 and 18.
■ If you do not confirm using the BREW/control knob (k), the time is recorded automatically after about 5
seconds.
Activate a delayed start-up when the time is already pre-set.
■ Select AUTO 1 or AUTO 2 by pressing the AUTO ON button. Press the BREW/control knob (k) to launch
auto-start program.
6B – TURBO FUNCTION
This function enables you to brew your coffee faster by reducing the cycle time.
■ Press the TURBO button. Fig. 11
■ The TURBO icon will appear on the screen.
■ This function will be saved in the memory of your coffee machine for future cycles. You can stop this function
by pressing the TURBO button once more.
6C – REGULAR OR BOLD
■ This feature allows you to make a coffee that is more or less full-bodied.
■ The BOLD feature increases the time of the cycle for a stronger coffee.
10