Renishaw PH10M-iQ PLUS Guide D'installation Et D'utilisation page 18

PH10M-iQ PLUS installation and user's guide
www.renishaw.com
Probe extension bars
Renishaw manufactures a comprehensive range of extension bars and adaptors to allow increased component access.
There are three types in the range:
• Autojoint to M8 bush ﴾PAA series﴿
• Autojoint to autojoint ﴾PEM series﴿
• M8 thread to M8 bush ﴾PEL series﴿
Autojoint to M8 bush
These extension bars connect directly to the autojoint of the PH10M-iQ PLUS head and terminate in an M8 bush. This permits the use of two-
wire touch-trigger probes.
Extensions
PAA1
PAA2
PAA3
The probe is fitted to the extension by hand and tightened by use of the S1 'C' spanner as shown.
The S1 spanner is designed to fail before damage can occur to the mechanical joint between the two parts. Using the S1 spanner, fully hand-
tighten the probe body into the M8 bush (0.3 Nm to 0.5 Nm).
Issued 12 2021
Length
32 mm
144 mm
300 mm
Material
Steel
Aluminium
Aluminium
Weight
57 g
85 g
144 g
18