Renishaw PH10M-iQ PLUS Guide D'installation Et D'utilisation page 13

PH10M-iQ PLUS installation and user's guide
www.renishaw.com
System description
Product
PH10M-iQ PLUS
HCU2
PHC10-3 PLUS
UCC T3 PLUS
UCC S3
The PH10M-iQ PLUS is a general purpose, versatile unit designed specifically for use on direct computer controlled (DCC) CMMs and
incorporates the following features:
720 indexing positions
0.4 μm indexing repeatability
7.5° indexing steps in both axes
300 mm extension bar capability *
Inferred qualification when mounted vertically or horizontally **
* NOTE: 450 mm extension bar capability with special order carbon fibre extensions.
** The inferred calibration procedure is different depending on the chosen orientation of the head.
WARNING: The components of the PH10M-iQ PLUS system are not compatible with PH9 and PH20 system components. No
attempt should be made to connect the PH10M-iQ PLUS system components to a PH9 or PH20 system as this will result in damage
to the product.
NOTE: On initial set-up of a PH10M-iQ PLUS system, a head localisation is required. Please refer to the software providers'
documentation for more information.
Specification
Repeatability of position (at a distance of 100 mm)
Accuracy of step spacing from theoretical position
Issued 12 2021
Description
A shank-mounted head with multiwired probe capability, a Renishaw
autojoint and inferred qualification
A hand control unit for use with PH10 measurement systems
A controller for use with PH10 measurement systems
Renishaw CMM controller with integrated PH10 PLUS controller
Renishaw CMM controller with integrated PH10 PLUS controller
<0.4 μm TP6A and stylus
±0.3 mm TP6A probe and stylus
13