Publicité
Les langues disponibles
Les langues disponibles
Remote control 2.4G long range 25m
Before using it for the first time, add the batteries to the remote control and pair it with the lamp head (see
•
procedure paragraph "before use" and below)
TRICK :
You can use a single remote control to control multiple projectors. You just need to perform the operation
pairing below:
1) Position the lamppost to OFF using the general power button located on the lamppost.
2) Press and hold the "MATCH" button on the remote control.
3) While keeping the match button pressed, position the floor lamp to ON using the general button.
4) The street light flashes, the pairing is successful.
The remote control is used to adjust the lighting power, lighting temperature, timer and motion detection according to
your needs. If the weather is very sunny, you can set the light with a higher power; In case of continuous cloudy days or
in winter with less sun, you can reduce the power to save energy. If you want to save more energy, you can activate the
motion detection mode in order to save the battery (lighting 30% then 100% in case of detection).
The illumination duration can also be set to 4 hours, 6 hours and 12 hours, if you want to save energy.
Please always set the light power first, then tap the time set as the last step. Press the "RESET" button to obtain the
default setting and cancel your settings.
Set color to warm white 3000K
Increase or decrease the light output
reset the light for 12 hour twilight
operation without motion detector.
Adjust the illumination
duration as needed.
Press the "reset" button to set
by 20% per step
12 hours.
Light up
Automatic twilight mode
AUTO
Set color to neutral white 4000K
Pairing the remote control
Activate the motion sensor, The
light will work at 30% power and
work at 100% power for 90 seconds
when it detects movement,
then return to 30% power
15
Publicité
