SUN AMEX Premium STELLAR Notice Originale page 14

BEFORE USE
1
INSTALLATION
1
Position your head on its base and rotate the assembly so that you form
a smiley face. there should be NO space between the light head and the
bracket.
3
Insert the light head onto the pole and tighten the two M8 * 16 screws
using a T-shaped wrench in the correct position. The 76 mm diameter
pole is the most suitable for the lamppost head.
+
ON
2
2
Tilt the lamp a little, don't drop the bracket, put the screw on the T-shaped
wrench, carefully place the screw inside the light bracket and tighten it,
install 4 M8 * 40mm screws one by a. Make sure the screws are tight
enough.
4
Press the light head button, then press "AUTO", the light will work from
dusk to dawn automatically with its default setting of 4hours 100% +
4hours 50% + 5hours 30% with sensor. Use the remote control to adjust
the power of the light and select the color of the light and adjust the
working time if necessary AT NIGHT
1) Position the lamppost to OFF
using the general power button
located on the lamppost.
2) Press and hold the
"MATCH" button on the remote
control.
3) While keeping the match button
pressed, position the floor lamp to
ON using the general button.
4) The street light flashes, the
pairing is successful.
13