Publicité
Les langues disponibles
Les langues disponibles
BATTERY AND CHARGING:
NOTE: The battery has been pre-charged at the factory. If the LED brightness is low, the charge may have
dropped during storage. It is advisable to charge the lamp for a whole day in the sun for its first use.
IMPORTANT:
In order not to damage the battery and its lifespan, it is recommended to recharge it at least every 3 months.
Once the first full charge of 8 hours has been carried out, it is imperative to position the button located in the
"ON" position to switch it on, having previously performed the remote control pairing.
ON - OFF POSITION
• Position the product and its solar panel in an open outdoor location, in direct sunlight, so that
the solar panel receives at least 8 hours of direct radiation per day. If the solar panel is placed
in the shade, the load will be reduced and the illumination duration will be shorter at night.
• Depending on the time of year, weather conditions and the location of the solar module, the
lighting time may be reduced.
During summer the sun is higher in the sky and the amount of solar energy absorbed by the
solar panel is greater than when the sun is lower in the sky during other seasons of the year.
We therefore recommend reducing the light intensity and / or reducing the range of use using
the 6/8 / 12H timer function.
• If you install this solar bollard too close to a street light or other light source, it may affect the
twilight function and prevent the bollard from automatically turning on at night.
• In order not to damage the battery and its lifespan, it is recommended to recharge it at least
every 3 months.
ON/OFF
1) Proceed with the pairing of the remote control (see
procedure in the previous chapter).
2) Press the ON / OFF button to the ON position to power
the lamppost then use the remote control to control it.
3) Press the ON / OFF button again to switch to OFF
mode.
14
Publicité
