Publicité
Les langues disponibles
Les langues disponibles
IP4930_3BE63CP_00_140417:IP2848_38X42CP_01_100107.qxd 2014-4-17 11:06 Page 10
Care and Cleaning of Your Microwave Oven
BEFORE CLEANING:
Unplug oven at wall outlet. If outlet is
inaccessible, leave oven door open while
cleaning.
Warning/Menu Label:
Do not remove, wipe
with a damp cloth.
Inside of the oven:
Wipe with a damp
cloth after using. Mild
detergent may be used
if needed. Do not use
harsh detergents or
abrasives.
Oven Door:
Wipe with a soft,
dry cloth when
steam accumulates
inside or around the
outside of the oven
door. During cook-
ing, especially
under high humidity
conditions, steam is
given off from the
food. (Some steam
will condense on
cooler surfaces,
such as the oven
door. This is nor-
mal.) Inside surface
is covered with a
heat and vapor bar-
rier film. Do not
remove.
IT IS IMPORTANT TO KEEP THE OVEN CLEAN AND DRY.
FOOD RESIDUE AND CONDENSATION MAY CAUSE RUSTING
OR ARCING AND DAMAGE TO THE OVEN. AFTER USE, WIPE
DRY ALL SURFACES-INCLUDING VENT OPENINGS, OVEN
SEAMS, AND UNDER GLASS TRAY.
Glass Tray:
Remove and wash in warm
soapy water or in a dishwasher.
Roller Ring and oven cavity
floor: Clean the bottom surface
of the oven with mild detergent
water or window cleaner, and dry.
Roller Ring may be washed in
mild soapy water or dishwasher.
These areas should be kept
clean to avoid excessive noise.
AFTER CLEANING:
Be sure to place the Roller Ring and the
Glass Tray in the proper position and
press Stop/Reset Button to clear the
Display.
Outside oven surfaces:
Clean with a damp cloth.
To prevent damage to
the operating parts inside
the oven, water should
not be allowed to seep
into ventilation openings.
Do not remove waveguide cover:
It is important to keep cover
clean in the same manner as the
inside of the oven.
10
Control Panel:
• Covered with a
removable protec-
tive film to prevent
scratches during
shipping. Small
bubbles may
appear under this
film. (Hint - To
remove film, apply
masking or clear
tape to an exposed
corner and pull gen-
tly.)
• If the Control
Panel becomes
wet, clean it with a
soft, dry cloth. Do
not use harsh deter-
gents or abrasives.
Publicité
