Volpi KV390 Mode D'emploi page 39

G. Clean up the rubbish as shown and grease the
counter blade.
I. Screw the M3 hexagon socket screws with a
hex head wrench as shown.
M. Mount and tighten the M5 socket screw
clockwise as shown in the picture. Also insert
the rubber cap.
G
H. Grease the blade rack gear according to the
picture and reinsert the blade into its housing,
then correctly position and close the cover.
I
L. Turn the hexagon screw of the blade
counterclockwise as shown in the picture.
M
N. Place the hexagonal screw of the blade by
screwing counterclockwise as shown in the
picture, do not overtighten the nut. The
clearance between the blade and the counter
blade should not be less than 0.03mm.
H
L
N
39