Volpi KV390 Mode D'emploi page 36

• Press the trigger all the way and hold it for 3 seconds, after the beep press the trigger
twice in 1 second to open the blade, at the moment of opening you will hear another
beep indicating that you hace changed the opening to 50%.
• Press the trigger all the way again for 3 seconds and after the beep, press the trigger
twice in 1 second to open the blade again, the blade opening will return to 100%.
15. Maintenance and cleaning
Tools to be repaired must be sent to Customer Assistance Service. Use original part keeps the
tool good condition and safe.
Disconnect the battery from the tool before checking, maintaining and repairing the pruning
shear, to avoid risk of unexpected activation of the tool.
Warning!
In particular situations of very hard use, the blade and the handle could reach high temperatures. It is
recommended to handle the pruner with care, using protective gloves.
Please wear glove before you check the blade is sharp or not, that is to avoid blade hurt you.
Check the pruning shear frequently, this will keep tool safe and reliable.
•
Do not flush the tools or put it in water, it will cause short circuit or damage the device.
•
Keep ventilation, motor and handle cleaning, always use feather clean the device. Do not use
cleanser flush device, it will rust parts.
•
Clean the blade after every use, protect by oil or spray protection.
•
After continuous work for 8 hours, please open the trigger cover protection of the equipment and
clean up wood chips and other impurities
15.1. Sharpening
This step is critical because it determines the quality of cut, blade life, and autonomy and battery life. The
harder it is to cut, the more energy your machine will use.
• Sharpening is very important to keep blade in good condition and ensure long life.
• The tool have attached accessory to sharp blade.
• Always check blade is in good condition before to start work. Of course, the frequency of sharpening
depends on the nature of the sheared wood (hardness and diameter), pruning rate and sharpening
tools (special abrasive tools are provided). As a result, the blade must be checked frequently during
the initial period of use to determine the appropriate grinding time (check every 15 minutes and you
will quickly calculate)
36