Continental Fireplaces X 70 Serie Manuel D'installation Et D'opération page 30

to CPI position to enable remote CPI operation. If the switch is set to IPI
then it will only work in IPI regardless of what is set on the remote control
handset.
operation
EN
ADD TITLE: LOW BATTERY / MANUAL BYPASS
8.9 low battery
The life span of the remote batteries depends on various factors: quality of the batteries,
the number of ignitions, etc.
When the transmitter batteries are low, a battery icon will appear on the LCD display
before all battery power is lost. When the batteries are replaced, this icon will disappear.
When the receiver batteries are low, no "beep" will be emitted from the receiver when
it receives an on/off command. This in an alert for the receiver that there's low battery.
When the batteries are replaced the "beep" will be emitted from the receiver when the on/off key is pressed.
If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding the
three position slider switch on the receiver to the on position. This will bypass the remote control feature and the
appliance main burner will come on if the gas valve is in the on position.
ADD TITLE: IN THE EVENT OF A POWER FAILURE
8.10 battery holder / backup installation
If the receiver is equipped with batteries they will enable fl ame height control or on/off function to control the
A. The battery holder is located in the valve compartment,
appliance during a power failure. Blower and Night Light™ operation is not possible. Refer to "appliance
accessible for programming the remote.
operation" section when communications between receiver and transmitter have been lost. The receiver will
emit a "beep" sound to confi rm programming has been successful once power is restored. During a power
B. Install 4 AA batteries, Ensure that the positive and negative failure, if the appliance was on, the fl ame height will stay at the setting prior to the failure. If off when the failure
occurs and then turned on, the fl ame height will come on at "Hi". The fl ame height can then be controlled by the
ends correspond with those identified in the battery holder.
remote.
C. In the case of a power outage, the 3 position slider switch
needs to be in the "ON" position (left).
note:
Ensure the 3 positions slider switch is in the "REMOTE"
position (middle).
8.11 night light replacement
Your appliance comes equipped with our Night Light ™. The light has
been pre-wired and can be controlled from the switch on the control
panel.
It is recommended that the Night Light ™ be in the "OFF" position when
the appliance is on.
In the event the lamp or lens needs to be replaced:
• Unplug the light from inside the appliance.
• Remove the 4 screws that secure the lens frame. This frame retains
the glass lens.
• The lamp can now be accessed. It will pull straight out of the socket.
note:
Do not handle the lamp (bulb) with bare fingers as it may be
hot. Use a clean, dry cloth for protection.
• Replace the lamp with Wolf Steel parts only, as lamp and lens are
special "high temperature" products.
• When re-installing, ensure integrity of gasket seal.
note:
Do not over-tighten the screws, as this could break the lens.
THE FIREBOX MUST BE SEALED.
"Light leakage" from the upper louvre area may be noticed. The holes in the lamp housing are necessary for
ventilation and must not be covered.
30
W415-1797 / A / 05.07.18
OFF
Flame Off
MAX
76
child lock
OFF
73
73
Flame Off
child lock
Room Temperature
Room Temperature
68
ON
68
ON
Set Temperature
Set Temperature
SMART
SMART
MAX
76
MAX
76
OFF
OFF
Flame Off
Flame Off
child lock
child lock
Temperature Key
On / Off Key
Up / Down Arrow Key
Temperature Key
Flame at level 1
Up / Down Arrow Key
Mode Key
76
76
°F
Mode Key
°F °F
23
°F °C
23
°F °C
Flame at level 1
76
°F
76
°F
76
°F
76
°F
76
°F
RESET/PROGRAM BUTTON (PRG)
76
°F °F
76
°F °F
LENS ASSEMBLY
Flame at level 1
76
Flame at level 1
°F
76
°F
OFF ON
Hi
OFF ON
Flame at level 5 Flame at "Hi" level 6
76 76
76
°F
76 76
IPI CPI
°F
76
Hi
Flame at level 5 Flame at "Hi" level 6
76 76
76
°F
°F
IPI CPI
68
76
°F
68
76
°F
OFF
76
°F
OFF
76
°F
76
°F
SCREWS
Flame at level 5 Flame at "Hi" level 6
76
23.3
Flame at level 5 Flame at "Hi" level 6
°F
FIREBOX TOP
IPI CPI
76
°F
IPI CPI
°F
°F
°F
°F
76
°F
°F
Hi
76
°F
Hi
76
°F
76
°F
76
°F
76
Hi
°F
Hi
76
°F
76
°F
GASKET
LENS
FRAME