Télécharger Imprimer la page

Electrolux EDH3786GDE Notice D'utilisation page 30

Publicité

Les langues disponibles

Les langues disponibles

30
www.electrolux.com
• Start a short programme (e.g. 30
minutes) with moist laundry.
9. DAILY USE
9.1 Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and
options for the type of load.
The display shows the programme
duration.
4. Press the Start/Pauze (Start/Pause)
touchpad.
The programme starts.
9.2 Starting the programme with
delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
3. Press the Start/Pauze (Start/Pause)
touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
CAUTION!
Make sure that when you
close the door, the
laundry does not catch
between the appliance
door and the rubber seal.
You can delay the start of
a programme from a
minimum of 30 minutes
to a maximum of 20
hours.
At the beginning of drying
cycle (3-5 min.) there could
be a slightly higher sound
level. It is because of start of
the compressor that is
normal for compressor
powered appliances such:
refrigerators, freezers.
9.3 Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
9.4 At the end of the programme
When the programme is completed:
• An intermittent acoustic signal
operates.
• The indicator
• The indicator
• The Start/Pauze (Start/Pause) indicator
is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• The indicator
flash.
• The indicator
flash.
flashes.
flashes.
is on but does not
is on but does not

Publicité

loading