Modem / Pc Link - Dimplex WPM 2006 plus Instructions De Montage Et De Service

Configuring the Heat Pump Heating System

6.5 Modem / PC Link

It is necessary to configure the modem in the "Modem" menu.
Refer to the installation instructions of the remote diagnosis
system used regarding installation regulations. Check all
changes to the factory settings very carefully because an existing
connection could be severed.
Adjusting the interface for remote diagnostics
Selects the baud rate with which data is exchanged
via the serial interface. Ensure that the same baud
rate is set on both sides of the communication
system.
An address can be assigned to each connection.
This value should remain set to 001 in normal
operation.
Setting the protocol specifies which type of remote
diagnostics are used (local or modem)
The remote diagnostic function can be locked by a
password
This function is currently not in use
This sets which type of telephone connection is
used for remote diagnostics via modem
This sets the number of rings after which the
controller for remote diagnostics answers
This function is currently not in use
For diagnostic purposes (in combination with a
pCO web card), a function can be activated here
which changes the value of a variable at specific
intervals. The time basis is 1 minute. The factor is
entered in minutes. If the factor is zero, then the
function is deactivated. The variable is output to a
higher-level diagnostics device and set from "0" to
"1" for 30 seconds during the interval.
Setting range
Display
19200 Always
9600
4800
2400
1200
0 Always
...001...
199
Local Always
Remote
GSM
0 Always
... 1234...
9999
Always
Tone Always
Pulse
0 Always
... 1...
9
No Always
Yes
0 Always
...
30000
EN-21
6.5